Shop Tip: Router Dado Sled for the Thomas Walnut Dresser



I got about 2 hours of shop time tonight. I was working alone so I wasn’t going to try to push any big pieces through the saw. I need to cut the top, back, and bottom to their final sizes, and also rip the front into the strips that will make up the front for the drawers. I’ll have to do that when I have help.

Knowing that I’ll have to make some dados in the sides for the drawers, and knowing that I’ll want those to fit the dust frames perfectly, I made a Router Dado Sled. Basically, I can set the cutting width of this to match the material thickness exactly, clamp it to the piece, and let the router do the work.

 

IMG_0258

Here you can see the sled, from the bottom. One sled rail is fixed square to the cross rails with glue and screws. The other floats free in two grooves. You can see the grooves in the cross pieces that let me adjust the width. The knobs that lock in the floating sled rail are on the bottom so that they don’t interfere with the router.

 

IMG_0260

Set the sled face down on the workbench, and put a scrap piece of the material that will be going into the dado in it. Push the material against the fixed sled, and the free sled against the material, tighten the knobs. The Router Dado Sled is now set for your material.

 

IMG_0261

Now turn the sled right side up, clamp it to your piece, and rout the dados. Probably best to minimize tear out by putting the back cross member up against the piece. I’m also going to check for square before making cuts, but this could also make angled cuts for shoe racks, louvers, etc.

 

IMG_0262

Here you can see that the bolts for the knobs have flat oval heads. They are recessed so they won’t get in the way, and I cut oval holes for them so they won’t spin.

 

This sled will be used on this project to cut four dados, and I’m sure I’ll use it on other projects. Now I need to get the perfect router bit for it.

One thought on “Shop Tip: Router Dado Sled for the Thomas Walnut Dresser

  1. Pingback: Out-takes from the Upper Cut Woodworks feature on Tom’s Workbench | Upper Cut Woodworks

Leave a Reply